繁體| 简体| EN  會員註冊 登入 會員中心

INSTALLATION & OPERATION


Installation of Thermostatic LED Heater DEVICE (LED THD ®):
(1) Infrared receiver should be placed outside salt crystal lamp for the sake of receiving signals of remote controller.
(2) When connected to the power source initially, it’s automatic to set circulative mode of warm & cool cross-flow light.
1. Thermostatic LED Heater Device inserted under Salt Rock Body
2. Thermostatic LED Heater Device inserted between Base and Salt Rock Body
3. Thermostatic LED Heater Device installed in the receptacle.

The Function of Remote Controller:

Keep Warm

Note: After pressing the button, warm golden glow would turn off slowly and Thermostatic LED Heater Device would still keep warm at 50°C.

Cool White (5400K)

Description: The cool white light has 7 light intensity level for switching after pressing the button.

Small Night Light

Description: Bland and soft nightlight with cool and warm luminance for switching after pressing the button.

C&W (Breathing Soul of Salt Mood)

Description: The normal cool and warm cross-flow white light has 4 light intensity level for switching after pressing the button.

Warm White (2700K)

Description: The warm white light has 7 light intensity level for switching after pressing the button.

Off (Recommended not to use usually)

Note: Press the button two times within 2 seconds, the light will flash and then turn off. Besides, the heating will not be supplied by the Thermostatic LED Heater Device. (Recommended not to use usually which prevent salt deliquescence)

MAINTENANCE AND NOTES


1. To keep a certain amount of light penetration on the surface of salt crystal and maintain the effect of attracting water molecules in the air which dried out the water vapor. It’s recommend wiping down the salt lamp with a cloth a few times a week to clean it.
2. If soot deposit on the surface of salt crystal is hard to wipe out by dry cloth, use wet cotton cloth or sponge to clean out as possible. Do not soak or wash the salt crystal in the water for cleaning.
3. Intelligent Healing Salt Crystal Lamp can put in the bathroom, bedroom or basement with humid environment. It should make sure that the Thermostatic LED Heater Device is on working to avoid salt deliquescence.
4. Salt Crystal Lamps have the hygroscopic property which easily attract water molecules and condense on the surface, it’s recommended that turn on the MD of Thermostatic LED Heater usually or turn on the “Keep Warm” function only to maintain constant temperature.
5. It can reach optimum condition when turn on Thermostatic LED Heater Device all the time. But, if you will not use for a long time, please be wrapped in plastic bag or film for preventing salt deliquescence.
6. Avoid collision or drop

<NOTES>

1. Do not slam or press the product heavily.
2. Do not mix different kinds of the battery; otherwise, battery life and remote control function would be damaged easily.
3. Please remove the battery to prevent battery leakage when the remote controller will no longer use for a long time.
4. This product is suitable for 1.5V Carbon Zinc Batteries (AAA) rather than alkaline batteries.

<SERVICES>

1. No service for the damage caused by natural disaster or any force-majeure circumstances.
2. No service for any improper operation without obeying the manual of installation & operation.
3. No service for any product with dismantling or fixing which not authorized by our company.